13
85812
PRE-OPERATION CHECK LIST
● Check Temperature
- Refer to the Operators
Manual for the truck to determine if the temperature
is too cold or too hot to operate the trucks hydraulic
system. Determine if the trucks hydraulic system
requires a warm-up period before operating the
WideSpin 1530 TM.
● Check
- Level of hydraulic fluid in trucks reservoir
tank. Correct level to full if needed.
● Check
- Level of oil in trucks engine crankcase.
Correct level to full if needed.
● Check
- Check the hydraulic connections from the
top dresser to the truck. Connections must be
proper and secure. Refer to the manual for the
mounting kit for more information.
● Check
- Inspect for damage, wear, and missing
parts. Do not operate the 1530 TM top dresser with
a damaged or defective parts. Refer any needed
repairs to the proper service personnel.
● Check
- Visual check for hydraulic leaks.
TO AVOID SERIOUS INJURY,
Do Not Use Your Fingers Or Hands
To Check For Hydraulic Leaks. High
Pressure Leaks Can Puncture The
Skin And Force Oil Into The Body. This
Can Cause Severe Injury Or Death.
WEAR EYE PROTECTION.
● Check
- The hand held ON/OFF switch is secure at
the operator position. DO NOT put hand held switch
inside of the hopper.
● Check
- The hand held ON/OFF switch is in the OFF
(
O
) position for both the conveyor belt and the
spinner assembly.
● Check
- Power supply harness is plugged into the
1530 TM and is properly attached to the trucks
battery.
● Check
- All guards and deflectors are in place.
● Check
- All hardware on the mounting brackets.
Hardware must be tight, pins must be securely
inserted.
● Check
- Visually inspect the inside of the 1530 TM
hopper for tools, shovels, rocks or debris remaining
from earlier use. Hopper must be empty.
HAND HELD SPINNER AND CONVEYOR BELT
ON/OFF SWITCH
(See Figure 4)
The switch controls the activation of
both the conveyor belt and the spinner
assembly. Refer to Figure 4 for switch
positions. Before starting the engine,
place the switch in the OFF (
O
) position
for both the conveyor belt and the spinners.
If the switches are in the ON (
I
) position,
the belt and the spinners will start to operate as soon
as the engine is started and the hydraulic system is
activated.
Start and stop operation will happen as soon as the
switch is placed on the ON (
I
) position, there is no
time delay in operation. The switch operates the same
in Lightspread or Heavyspread.
During operation, keep the switch box at the operator’s
position on the tow vehicle. When not is use, hang the
switch box on the top of the hopper. DO NOT place
the switch box in the hopper!! Damage will occur if the
switch box becomes tangled in the spinner wheels.
DANGER
Spinners ON
Conveyor ON
Spinners ON
Conveyor OFF
Spinners OFF
Conveyor OFF
LEFT
POSITION
CENTER POSITION
RIGHT
POSITION
FIGURE 4
HAND HELD SPINNER AND CONVEYOR BELT ON/OFF SWITCH
OP85811-02
OPERATION
