EN
MINI AVANT
IS11/11 - 561185
7 - USE AND OPERATION
7
-
Pag. 10/10
THIS MANUAL IS PROPERTY OF
-
ANY TOTAL OR PARTIAL REPRODUCTION IS STRICTLY FORBIDDEN
Cap.
2
1
1
2
3
4
FIG.32 FIG.33
- Use a jet of water to wash the hopper, mixing device and pump intake.
- Re-mount the vibrating frame.
- Re-mount the intake collector and the flow valve body, checking that the sealing ring (FIG.33-REF.1) adheres perfectly to the
profile (FIG.33-REF.2). This confers perfect sealing between the two elements. The contact surfaces must be perfectly clean.
- Fill the hopper with water, connect the mortar piping, lower the by-pass lever and start the machine.
- Repeat the operation until clean water escapes from the piping.
- Switch the machine off using the master switch positioned on the electric control board.
- Remove the water remaining inside the hopper b opening the lower joint in the pump unit and sliding the intake collector out
from the sealing ring(FIG.33-REF.1).
