EN
MINI AVANT
IS11/11 - 561185
7 - USE AND OPERATION
Cap. 7 -
Pag. 7/10
THIS MANUAL IS PROPERTY OF
-
ANY TOTAL OR PARTIAL REPRODUCTION IS STRICTLY FORBIDDEN
7.5 EMERGENCY
STOP
For the emergency stop, turn the red master switch on yellow background to position "0" zero (Single-phase and Three-phase)
(FIG.15-REF.1) or press the mushroom-shape switch on the electric control board (FIG.29-REF.9).
Proceed as described in paragraph 2.5 to put the machine in total safety.
7.6
STARTING THE MACHINE
Use nytril fibre gloves for protection against cuts and abrasions, preferably models with CE 940072 certification
and goggles that offer total protection for the eyes , with shatter-proof anti-misting lenses
The gun must never be aimed at the operator and towards third parties.
The machine must always function with material or water in the hopper(FIG.26). If this is not the case,
premature wear will occur on the pumping piston.
7.6.1
MINI AVANT SINGLE/THREE PHASE
- Start the engine by turning the master switch (FIG.27-REF.1A) to position 1 (ON).
The indicator (FIG.27-REF.3A) switches on indicating that the power supply voltage value is correct. Switch-off
of this indicator, even momentarily, is a symptom that the voltage is below the minimum value acceptable:
check the power supply line.
- Open and close the cock quickly two or three times (FIG.27.REF.6) to check the correct functioning of the pneumatic control:
MINI AVANT must stop and re-start.
For MINI AVANT THREE-PHASE only
- Make sure that the engine turns in the right direction (see par.5.4.1.1 ).
- Check that the pump is engaged: the slurry must circulate in the hopper. If this does not happen:
• switch the machine off by turning the master switch (FIG.27-REF.1A) to position 0 (OFF).
• Open the upper joint of the pump unit (FIG.05-REF.2).
• Remove the ball valve.
• Pour slurry into the valve body (FIG.05-REF.3).
•
Re-start.
7.6.2
MINI AVANT VARIO
- Start the engine by turning the master switch (FIG.29-REF.1B) to position 1 (ON).
The indicator (FIG.29-REF.3B) switches on indicating that the power supply voltage value is correct. Switch-off
of this indicator, even momentarily, is a symptom that the voltage is below the minimum value acceptable:
check the power supply line.
Note: the indicator on also indicates that the sieve or alternatively the safety grill is correctly positioned and the bodywork is
closed properly.
- Position the engine protector knob (FIG.29-REF.15) in position 1.
- Position the selector switch (FIG.29-REF.14) in position:
• 1 to use the pump with the pneumatic remote control,
• 2 to use the pump with the electric remote control,
-
