TURBOLOCK TL116 17
Step 5.
Gently insert the power cable connector into the connector
of the inside section to snap them together. And collect the
connected power cable into the slot of inside section (Fig. 9).
Step 6.
Fit the inside section over the plate, and use three inside
screws fasten it to the back of the door.
Note the placements for the different sized screws (Fig. 9).
Make sure all screws are tightened.
Step 7.
Adjust the L/R switch as needed (Fig. 10), and add the 4xAA
batteries or rechargeable batteries into battery compartment.
Then slide the cover down over it (Fig. 11).
Do NOT force the cable’s connector end through any part of the lock. Damaging the connector will make the lock
unusable.
Step 8.
The lock should now be ready to use.
It’s highly recommended to use the default passcode to test the lock to make
sure it works before closing the door.
See Section 6 for information on the default admin passcode.
Fig. 9
1.Switch must point
towards the closest
door edge of the lo
ck.
2.Change batteries immediately after
receiving first low-batte
ry warning.
RESET
Left and right
lock switch
1.Switch must point
towards the closest
door edge of the lo
ck.
2.Change batteries immediately after
receiving first low-batte
ry warning.
RESET
Left and righ
t
lock switch
Connectors
Horizontal
Inside Knob
2x Inside
Screws
1x Inside
Screw
Fig. 10
Inside Section
Latch on the right
L/R switch pushed to
R side + thumb turn
horizontal
Latch on the left
L/R switch pushed to
L side + thumb turn
horizontal
L R
L R
Fig. 11
4 x Batteries
Cover
