![Turbolock TL116 Manual Download Page 10](http://html.mh-extra.com/html/turbolock/tl116/tl116_manual_1181270010.webp)
10 TURBOLOCK TL116
3.2 Main Installation
Step 1.
Start with the outside section. Turn the latch pin vertically and
remove the key from the key hole. Gently feed the power cable
under the latch and thread the latch pin through the square hole
in latch. The latch pin must be vertical while inserting the square
hole in the latch (Fig. 6).
Step 2.
If needed, have someone hold the door itself or hold the outside
section flat against the front of the door. And align the plate
on the back of the door while making sure to gently thread the
cable under the latch. Gently thread the power cable through the
square hole of the plate. Then use the 2x mounting screws to
fasten the plate to the back of the door. Make sure all screws are
tightened. (Fig. 7)
Step 3.
Insert the key into the key hole to turn the latch pin horizontally. The bolt should now be extended (Fig. 8).
Step 4.
Remove the battery compartment cover on the inside section and turn the inside knob horizontally before installing.
Fig. 6
1.Switch must point
towards the closest
door edge of the lo
ck.
2.Change batteries immediately
after
receiving first low-batte
ry warning.
RESET
Left and right
lock switch
Vertical Latch Pin
1.Switch must point
towards the closest
door edge of the lo
ck.
2.Change batteries immediately
after
receiving first low-batte
ry warning.
RESET
Left and right
lock switch
Power Cable
Fig. 7
1.Switch must point
towards the closest
door edge of the lo
ck.
2.Change batteries immediately after
receiving first low-batte
ry warning.
RESET
Left and right
lock switch
Mounting
Screws x 2
Power Cable
Fig. 8
1.Switch must point
towards the closest
door edge of the lo
ck.
2.Change batteries immediately
after
receiving first low-batte
ry warning.
RESET
Left and right
lock switch
Horizontal
Latch Pin
Bolt