TurboLock TL111WM 13
Step 4.
Feed the power cable through the battery compartment and make sure the side with inside screw is downward.
(Fig. 7)
Step 5.
Gently pull out the power cable connectors and snap them together. Once connected, gently collect the two cables
back into the battery compartment.
(Fig. 8)
Step 6.
Install 4x AAA batteries into battery compartment. Cover the inside knob over battery compartment and make sure
the side with inside screw is downward. Use the hex key to tighten the inside screw (clockwise) to complete the
installation.
(Fig. 9)
Hex Key
Power Cable
(Fig. 7)
Power Cable
(Fig. 8)
4 x AAA Batteries
Inside Knob
Hex Key
(Fig. 9)
Do NOT force the cable’s connector end through any part of the lock. Damaging the connector may make the lock
unusable.
Step 7.
The lock should now be ready to use.
It’s highly recommended to use the default passcode and the app to test
the lock before closing the door to make sure it works before closing the door.
See Section 6 for information on
the default admin passcode. See Section 9 for information on the app.
Screw
clockwise
to tighten.