12 TurboLock TL111WM
3.2 Main Installation
Step 1.
Start with the outside knob. Gently feed the power cable and tail piece through the square hole in latch. Thread the
two pegs through the smaller round holes. If needed, have someone hold the door itself or hold the outside knob flat
against the front of the door afterwards.
(Fig. 4)
Do NOT force the cable’s connector end through any part of the lock. Damaging the connector may make the lock
unusable.
It’s highly recommended to leave the door open during installation.
Step 2.
Align the back plate on the back of the door, making sure the slot is facing upward. Carefully feed the power cable
through the center hole of the back plate. Tighten the 2x mounting screws (clockwise) to fasten the back plate to the
door. Make sure both screws are tightened.
(Fig. 5)
Step 3.
Feed the power cable through the back plate cover, and cover it on the back plate part, then use the hex key to tighten
the inside screw (clockwise) at the bottom of back plate cover.
(Fig. 6)
(Fig. 5)
2 x Mounting Screws
Slot is upward
Back Plate
Tail Piece
(Fig. 4)
(Fig. 6)
Inside Screw
Power Cable
Back Plate Cover
