turbofan G32M, Operation Manual, Page: 6 / 24

Location
• This oven must be installed in an area of adequate air supply. To ensure correct ventilation for the
motor and controls the following minimum installation clearances are to be adhered to:
• This oven must be fitted on supplied legs in all installations, unless installed on a manufacturers
stand.
• Position the oven in its working position.
• Use a spirit level to ensure oven is level from side to side and front to back. (If this is not carried
out, uneven cooking could occur). The legs used with bench/floor mounting or provided with
stands are adjustable and will require adjusting in levelling the unit.
• The unit should be positioned such that the operating panel and oven shelves are easily reachable
for loading and unloading.
• Adequate ventilation is essential. DO NOT obstruct the air flow around the ventilation slots.
Electrical Connection
This oven is fitted with an approved power supply cord via an electrical junction box at the right hand
rear of the unit. Should changing of the cord be necessary then follow the instructions given below:
• Remove right hand side panel to allow access to the terminal block and strain relief cable clamp.
• The cable can be fitted through the small grommet and held by the cable clamp.
Installation
4
Important:
THE VENT LOCATED ON THE OVEN TOP MUST NEVER BE OBSTRUCTED.
Supply Requirements (continued)
Natural Gas LPG Natural Gas - UK Propane - UK
(G20) (G31)
Operating Pressure 0.85 kPa 2.25 kPa 10 mbar 35 mbar
(3.5” w.c.) (9.0” w.c.)
Gas Connection ½” BSP Female ½” BSP Female
½” NPT Female (Canada only)
Electrical Connection 220-240 Volts AC, 50Hz, 0.7A, 0.168kW, Single Phase
220 Volts AC, 60Hz, 0.7A, 0.168kW, Single Phase
110 Volts AC, 60Hz, 2.0A, 0.12kW, Single Phase
Cold Water Connection ¾” B.S.P. (80psi maximum pressure)
Supply Pressure 1.13 kPa 2.75 kPa 20 mbar 37 mbar
(4½” w.c.) (11” w.c.)
Top 200mm / 8” (or 600mm / 24” from a combustible surface)
Rear 75mm / 3”
Left-hand side 75mm / 3”
Right-hand side 75mm / 3” (Fixed installations require at least 500mm (20”) clearance at
the right hand side for service accessibility.)