precautions to avoid possible exposure to
excessive Microwave energy
• DO NOT attempt to operate the top oven with the door open
since open-door operation can result in harmful exposure to
microwave energy. It is important NOT to defeat or tamper
with the safety interlocks.
• DO NOT place any object between the oven front face and
the door or allow soil or cleaner residue to accumulate on
sealing surfaces.
• The oven should not be adjusted or repaired by anyone
except properly qualified personnel.
• DO NOT operate the oven if is damaged. It is particularly
important that the oven door close properly and that there
is no damage to the: (1) door (bent), (2) hinges and latches
(broken or loosened), (3) door seals and sealing surfaces.
WarNiNG: Grounding instructions
This appliance must be connected to a grounded, metallic,
permanent wiring system, or an equipment grounding
conductor should be run with the circuit conductors and
connected to the equipment grounding terminal or lead on
the appliance.
do NoT TouCh heaTiNG eleMeNTs or iNTerior
surfaCes of oveN
Heating elements may be hot even though they are dark
in color. Interior surfaces of an oven become hot enough
to cause burns. During and after use, do not touch, or let
clothing or other flammable materials contact heating
elements or interior surfaces of oven until they have had
sufficient time to cool.
service
Should this appliance require service, please call TurboChef
Customer Service (866-447-3783). A qualified service
representative will assist you and – if required – coordinate
a service visit by an authorized service agent in your area.
power Connections
To avoid potential hazards, only the manufacturer, its service
agent, or a similarly-qualified person should replace a damaged
power cable. Flexible conduit, conductors and connectors are
supplied the manufacturer. Oven must be connected using
the flexible conduit and conductors provided.
self-Cleaning oven Guidelines
Clean the oven only in accordance with the guidelines
provided on this page, page 19, and page 27.
• Before self-cleaning the oven, remove broiler pan, grid,
racks, and other cookware. Clean only parts listed in
manual.
• Listen for fan – a fan noise should be heard sometime
during the cleaning cycle. If not, call TurboChef Customer
Service (866-447-3783) before self-cleaning again.
• DO NOT clean the door gasket. The door gasket is essential
for a good seal. Care should be taken not to rub, damage or
move the gasket. DO NOT clean with metal scouring pads.
Pieces can burn off the pad and touch electrical parts
involving a risk of electrical shock.
• DO NOT use oven cleaners. No commercial cleaner or
oven liner protective coating of any kind should be used in
or around any part of the oven. Residue from oven cleaners
will damage the inside for the oven when the self-clean
cycle is used.
• In the event the oven is malfunctioning in the self-cleaning
mode, turn off or disconnect appliance from power supply
and have serviced by a qualified technician.
• Complete instructions on the operation of the self-clean
mode can be found on pages 19 and 27.
rf interference Considerations
The appliance has been tested and was determined to be
in compliance with applicable portions of FCC part 18
requirements and to the protection requirements of Council
Directive 89/336/EEC on the approximation of the laws of
the Member States relating to electromagnetic compatibility
at the time of manufacture. However, some equipment with
sensitivity to signals below these limits may experience
interference.
If any equipment experiences interference, the following
steps should be considered:
• Increase the physical distance between the sensitive
equipment and this oven.
• If the sensitive device can be grounded, do so following
accepted grounding practices.
• If battery-powered microphones are being affected, ensure
that the batteries are fully charged.
• Keep sensitive equipment on separate electrical circuits
if possible.
• DO NOT route intercom wires, microphone wires, or
speaker cables near the oven.
General safety instructions
ii
SAVE THESE INSTRUCTIONS
