16
Final Grill Assembly Step
When you have finished assembling your grill,
be sure that all screws are tightened for safe
operation of your grill.
Before each use of the grill, make sure the
Grease Tray is fully seated under the Grill Bowl.
CAUTION: Before each use of your grill, inspect
the Grease Tray, Grease Tray Heat Shield and in-
side of the Grill Bowl to be sure there is no exces-
sive grease and debris buildup. Clean the Grease
Tray, Grease Tray Heat Shield and inside of the
Grill Bowl frequently to eliminate grease/debris
build-up and to prevent grease fires.
(for Model BTE3821(A,B)LP/NG)
Spark Electrode Tip
Spark Receiver
Spark Gap 3/16"
Gas Collector
Box
AA Battery may be installed backwards.
Electric wires may be loose. Remove the AA Battery
and inspect the Ignitor Junction Box found behind
the Control Panel and reconnect any loose wires.
-
-
Main Burner Electrode Check with the
assistance of another person, perform this
Electrode Check before proceeding.
Be sure all control knobs are set to "OFF"
and open the grill lid.
Have your assistant stand to the right of the grill
and look toward the front of the grill bowl.
Never
put your face inside the grill head.
Push and turn burner control knob to and you
will hear a "clicking" sound and your assistant
would see a tiny blue spark within each gas
collector box. If a spark is present, the electrode
tips are properly positioned.
If no spark is seen, the spark gap needs to be
adjusted as follows:
This test will ensure that the Spark Electrode Tips
are properly positioned so your grill lights easily.
•
•
If the gap between the spark electrode tip and
receiver is more than 3/16" wide use needle nose
pliers to gently squeeze the gas collector box to
narrow gap.
Recheck the electrode again, if no "clicking" sound is
heard:
Rotisserie Burner Electrode Check
Push and turn rotisserie burner control knob to .
Look for spark between electrode tip and spark
receiver tip.
If you don't see a spark from the rotisserie burner,
adjust the gap between the electrode tip and spark
receiver tip to 3/16" wide.
Install Cooking Components
9
Place the flame tamer with ceramic onto the lower
ledge of the grill bowl above the burners.
Place the cooking grids onto the upper ledge of
the grill bowl above the flame tamer racks.
Place the warming rack onto the warming rack
brackets on the grill bowl side panels.
Warming Rack
Cooking Grids
Flame Tamer With Ceramic
(For BTE3221B: 4pcs)
(For BTE3821B: 5pcs)
7
8
9
(For BTE3221B: 4pcs)
(For BTE3821B: 5pcs)
