- 17 -
PREPARING THE PATIENT LIFT FOR USE
1.
Plug the hand control, leg actuator (For P425 and P655
Full Electronic Lifters Only) and up-down actuator into the
receptacles on the bottom of the control unit.
2.
Check and tighten all hardware BEFORE operation.
3.
Plug the power cord into common household 110 or 220
Volt AC receptacle to charge the battery.
Plug for Leg Actuator
For P425, 655 only
Plug for Power Cord
Plug for Pendant
Plug for Up-Down Actuator
Control Unit
NOTE:
When plugged into an AC outlet the safe protect
feature turns on disabling the control pendent from
functioning. The unit will not function while plugged in.
- 18 -
CHARGING THE BATTERY
CHARGING THE BATTERY
NOTE:
It is suggested to recharge the battery daily to prolong
its life cycle.
1.
Place the battery on the control unit to charge battery.
Push the top of the battery against the mounting bracket until
there is an audible click, See more details on pages (15-16)
for Attaching the Battery Pack onto the Control Unit.
2.
Make sure the red emergency button is fully pulled out and
at the on position. (When emergency button is pressed down,
the circuit is off and the unit will not function or charge.
3.
Plug the power code into a 110 Volt outlet.
NOTE:
When plugged into an AC outlet the safe protect feature
turns on, disabling the control pendent from functioning. The
unit will not function while plugged in.
NOTE:
The charge LED will light up red while charging.
When fully charged, the LED will stop illuminating.
NOTE:
It will take approximately (4) hours to charge a battery
that requires a full charge.
When the charging power cord is plugged into an electrical
outlet, the red LED light on the left of the battery will come on.
When the built-in charging system senses a drop in battery
voltage,then the charging system automatically increases its
output to re-charge the battery.
