- 9 -
ASSEMBLY
ASSEMBLY
The lifter comes with pre-assembled main frame for easy
assembly
L
WARNING
Use only Tuffcare parts to complete this floor type patient lifter.
ASSEMBLING THE MAST ASSEMBLY TO THE BASE
STEP DOWN TO LOCK
1.
Set base on the floor. Lock both rear
casters before lifting up the mast.
2.
Lift up the mast to
the mounting bracket
on the base.
3.
Use the included wrench to
secure the bolts and nuts.
Note:
The two longer bolts are
used on side by side
(upper & lower holes),
short one is used on
the middle.
4.
Check and tighten all hardware BEFORE use.
- 10 -
ATTACH THE UP-DOWN ACTUATOR TO THE MAST
ASSEMBLY
1.
Position the up-down
actuator between the mast
bracket.
2.
Install the pin through
the holes of the up-down
actuator and mast bracket
and secure with hitch pin.
3.
Move the lift arm to align the
holes in the up-down actuator
with the holes in the arm bracket.
4.
Install the lower holding pin
through the holes of the up-down
actuator and arm bracket to
secure.