Tucker Auto-Mation SW10, Installation Manual

Page: 14 / 42

920.1020.12
14
STEP 4 Cont.:
OPTIONAL - PUSH ARM INSTALLATION WITH
INCREASED SPRING TENSION
•
Observe the Stop Point Screw on the operator as it is opening and ensure that it rotates to the
full open position against the open door stop - leave the switch in the Hold Open position
•
Manually move the door panel to the 90 degree open position
•
Insert the primary door arm spindle and adaptor at a position that is as close as possible to
allow alignment of the pencil line within the arm sleeve
•
Tighten the spindle adaptor to the operator
•
Slide the arm within the sleeve to finely adjust the exact full open door position - tighten the
Allen-head screws within the sleeve once complete
•
Place switch to the Off position and allow the door to
close
•
When closed, the secondary arm should be at
approximately 90 degrees to the face of the door as
shown - it is not imperative that the arm be at this
"exact" position
•
If the primary arm is re-positioned in the operator by a
tooth or two, the resulting arm position when closed
will look more like what is shown - this will also result in
a lower push force at the door.
•
Upon final installation of door arm assembly, press SW1
to launch a new setup - this is required for the control
to learn the new door stroke. Refer to Step 9, Power On
& Tune In Section if further instruction for setup is
required.
•
Upon successful completion of setup, proceed with remainder of installation.