920.1020.12
9
STEP 3
: INSTALL THE ARM ASSEMBLY - STANDARD APPLICATION
Follow the instructions listed below for a standard arm application using a "push" or a "pull" arm assembly.
If using a push arm, AND extra door closing force is require, follow the instructions on page 7 for "Optional -
Push Arm Installation With Increased Spring Tension"
PUSH ARM APPLICATION
Ensure the main power supply is removed or shut off at the control.
HINGE HUNG DOORS
CENTER PIVOTED DOORS
PUSH
APPLICATION
C/L of Hinge to C/L of Arm Mount
Bracket
Inside face of pivot
jamb to Spindle
Inside face of hinge jamb to
C/L of Arm Mount Bracket
13.5”
10.5”
16”
PULL
APPLICATION
Inside face of jamb to Back Edge of
Slide Track
Inside face of pivot
jamb to Spindle
Inside face of hinge jamb to
Back Edge of Slide Track
7 .5 ”
10.5”
8”
PULL ARM APPLICATION:
•
Includes double egress applications.
•
Ensure the main power supply is removed or shut off at the control.
•
Install the slide track assembly to the door at the specified location.
•
Attach the track with the screws provided.
•
Install the primary door arm and spindle onto the operator so that the arm is approximately 30 to 45
degrees past the door closed position.
•
Once the arm is installed and tightened, pull the arm towards the opening direction and insert the
drive block into the track assembly.
Summary of Contents for SW10
