28
Farm-Clean
Tuchel Maschinenbau GmbH
Illustration 1
Lower the pin after that. If the pin does not lower completely, turn the brush slightly until the pin lowers.
The angle of the brush can only be adjusted when the engine is not running.
5.4.4 Brush height adjustment
The height can be adjusted by using the turning handles. (see Illustration 1) With these turning handles it is possible to adjust
the height of the support wheels. With an optimum setting, the sweeping surface of the brush has a width of approx. 40 mm.
Illustration 1
The turning handles on both sides must be turned to equally adjust the height of the brush .
When the height of the brush is adjusted in such a way that it sweeps the sweeping surface extending over a bigger width, it
could result in increased brush wear. This shortens the brush's life.
5.5. Collector box
The most commonly used accessory for the sweeping unit is the Collector box. It
is available with a width of 75cm. The Collector box is not included in the machine; however, you can choose to order it.
The machine is equipped with two brackets (chrome colour) on both sides to mount
the collector box. The two bars on the collector box must be slid into these brackets.
Follow the procedure below to mount the GS collector box on the machine:
1. Take hold of both handles on top of the collector box and pull them out. (see Illustration 1) The two bars on the inside
will also slide up.
Illustration 1
2. Now you can lift the collector box and slide it on the mounting supports. Push the collector box forward so that both
bars slide into the brackets at the same time. (see Illustration 2)
