Tube-Line TL1700SR, Operator'S Manual

Page: 49 / 55

9-4
Section 9: Auto Control Option -
TL1700SR
Auto Wrap Mode Operation
Follow these instructions for best wrapping results.
1. Turn on display screen with toggle switch.
2. Press remote control ON (green) button to wake
remote if it is inactive.
3.
Pull plastic film from tensioner across the bed to
rear right corner, leaving enough over hang to tie
end of plastic to loaded bale.
4. Set display screen MODE to LOAD FROM
HOME if loading first bale from left side which
is the home position, shown in Fig.6 or if using
a skidsteer, set display screen MODE
field to
AUTO FROM LOAD POSITION , Fig.4 on pg.9-
2 , and press LOAD button on remote control to
rotate turntable to load position, Fig.7 , before
loading bale.
5. When loading machine is clear of the bale
wrapper, press the WRAP button on the remote
control to completely wrap bale.
6. After bale is wrapped the turntable will
automatically slow down on the last rotation
and stop at the home position. This is the only
acceptable position to unload a bale in.
NOTE: If the turntable is not parallel to the frame,
press and hold the RVS or FWD button on the
remote control until it is. This overrides the Auto
cycle. Rotation will stop as soon as the button is
released.
Fig.6 - Home Position
Fig.7 - Load Position
7.
If display screen field
TIP MODE is set to AUTO the turntable will tip as soon as last rotation is complete
and turntable magnet activates frame proxy sensor. Refer to Unloading Bales, pg.5-6 for proper bale
unloading and Bale Bumper Adjustment, pg.4-3 if bale is not unloading clear of the machine.
NOTE: If TIP MODE set to MANUAL , press the TIP DOWN remote control button for 3 seconds to unload
bale and then press the TIP UP button to fully raise the turntable.
8. If loading bales from home position load next bale over wrapped bale before repeating wrap operation.
Press LOAD remote control button if loading bales from angled position before repeating wrap operation.
9. Inspect wrapped bales and patch any holes and/or tears with heavy duty tape.
10.
Turn off display screen and remote control before transporting or leaving work site.
See
Auto Wrap Mode Display Adjustments, pg.9-2
to adjust functions to preferred settings.