Tube-Line TL1700SR, Operator'S Manual

Page: 45 / 55

1
2
5
8
7
8-1
Section 8: Hydraulic Control Power Pack Option -
TL1700SR
Section 8: Hydraulic Control Power Pack Option
Operation
The TL1700SR-P includes an onboard powerpack and hydraulic controls to operate it. The operating sequence
remains the same as a standard TL1700SR but is operated from the bale wrapper rather than from a
connected power unit.
To operate:
1. Power on the bale wrap computer with the toggle switch. See Section 7 for Bale Wrap Computer Operation.
2. Start the onboard powerpack engine, choke throttle as needed. Your wrapper is now circulating hydraulic
pressure through the machine. See engine manual for further details.
6. After applying wrap layers, rotate the table so the green UNLOAD decal is clearly seen from the operator’s
position. The turntable should parallel with the frame. Refer to
Unloading Bales, pg.5-6
.
7.
Push the TILT hydraulic lever to DUMP to unload the bale off the left side of the machine. This is the right
side when standing at the hydraulic levers.
3. Load bale as described on pg.5-5.
4.
Tie plastic film to bale twine or netting.
5. Wrap the bale by pushing the
ROTATE hydraulic lever FORWARD
to rotate the turntable clockwise.
NOTE: REVERSE ROTATE should not
be used to wrap bales.
DANGER: Only operate the hydraulic levers when standing in front of the controls! Unloading bale may roll
causing lifethreatening injuries or even death.
8. Pull TILT handle to LOAD position to return turntable to level position before loading next bale.
9. Load next bale.
10.
Rotate turntable to begin wrapping bale and to cut the plastic film from the unloaded bale.