Tube-Line TL1700SR, Operator'S Manual

Page: 22 / 55

1
2
3
1
3
3
1
2
2
TL1700SR -
Section 4: Adjustments and Repairs 4-3
Guide Roller Adjustment
Bale guide rollers may need to be adjusted to match bale size. Both guide rollers should be placed in the same
slot to keep the bale centered on the turntable rollers.
1. Remove lock pins from guide roller mounts.
2. Pull up guide roller shafts and place in desired position.
3. Reinsert lock pins.
Bale Bumper Adjustment
The bale bumper can be adjusted if you find that bales are unloading too heavily or are not rolling far enough
from the balewrapper. This may be the case for larger, heavier bales, or if the ground is soft. Using the roll-off
tarp also dampens the force of an unloading bale.
To adjust the bale bumper:
1. Remove hairpins from pins and
slide them out of outer tubes.
2. Pull or push roller tube to adjust
the distance the leading edge of an
unloading bale will contact it.
3. Lock roller tube in position with pins
and secure hairpins.