Tubbutec Sumtiple Kit Version – Construction Manual
This document describes the construction of the Sumtiple Kit. The following parts are
included:
•
1x Sumtiple PCB with SMD-Parts already soldered
•
1x Front panel
•
8x Jack sockets and nuts
•
1x RGB-LED
•
1x 10-Pin Header
•
1x Power supply cable
Tools needed to build Sumtiple:
•
Soldering iron, solder
•
Side cutter
•
Pliers
•
Multimeter for calibration
•
Small screwdriver
Construction
First you should start with preparing the parts needed for proper construction. Check the
pictures for a better understanding of what needs to be done.
First take the jack sockets, you need to pinch off a little of each pin. The pins need to be
cut to a length of 1mm. If they are not short enough, they will stick out of the board and
may touch a module next to it.
The sockets should look like the one left in the pictures above. When you have prepared all
8 sockets, take the PCB and put the sockets on it like shown.
