5
TST-Doc-507 WSD-M Manual-(
C
)
Note: To delete a single sensor code:
Press the “SET” button until it beeps (approx. 3 seconds). Push
the (+) button and scroll through the parameters until “LEARN
ID” appears. Press and release the “SET” button. Use the (+) or (-)
buttons to scroll to the tire you wish to remove. Press the “Set”
button to select that tire. It will start flashing. Press the “Back”
button for 3 seconds. You will hear 3 beeps. The code will change
to “FFF FFF” which will be flashing. Press “SET” once. The flashing
will stop and the ID code will be deleted.
Note: To delete all of the tire codes:
Press the “BACK” button for 6 seconds. You will hear 6 beeps.
“DEL ALL” will appear on the screen. Press “SET” once. You will
hear one beep. “FFF FFF” will appear. All ID codes are deleted.
Note: When in the coding mode, the display will time-out within
approximately one (1) minute if no buttons are pushed. At that
point, you will have to start the coding process again.
Note: Be sure the sensor being coded is at least two feet away
from the other sensors.
PRESSURE CODING (option #2)
1. Be sure your sensors are numbered. Screw the sensors
partly onto each valve stem in the order you numbered
them. Do NOT screw them down far enough to hear air
hissing out.
2. Push the “SET” button until it beeps. You are now in the
programming mode. The “HI PRESSURE SET” parameter
will blink at the bottom of the screen. Push the (+) button
and scroll through the parameters until “LEARN ID”
appears.
3. Quickly press and release the “SET” button. The first
tire on the display will blink. If you want to program a
