11
TST-Doc-507 WSD-M Manual-(
C
)
low-pressure alarms first and then, when done, set the high-
pressure alarms. The high pressure cannot go below the default
low pressure of 100 psi until the low pressure is reduced.
RESTORE PARAMETERS TO FACTORY DEFAULT SETTINGS
First, turn off the display. Hold the “BACK” and “SET” buttons at the
same time and turn the display back on. You will hear one beep.
The display will power back on and original factory parameters
will be restored. Tire codes will not be erased or changed.
DISPLAY ALERTS
Out of Parameter Alert
The 507 sensors send the tire pressure and temperature readings
to the display every two (2) minutes. If a tire is outside of the
parameters that were set, the audible alarm will sound and the
red LED light will immediately flash. The tire in question, pressure
or temperature for that tire, and warning type will also flash. The
audible alarm can be silenced for a short while by pushing any
of the buttons on the front of the display. The red warning light
will continue to flash until the pressure or temperature issue is
resolved and brought back into your preset levels.
Fast Leak Alert
When a fast tire leak is detected, the sensor will send that data
immediately to the display The audible alarm will sound and the
red LED light will immediately flash. The tire in question, pressure
for that tire, and FAST LEAK will also flash. The audible alarm can
