TSI Instruments AccuBalance 8370, Operation And Service Manual

Page: 30 / 58

22 Chapter 2
Figure 8 . Installing a support pole
8 Repeat step 7 until all four support poles are installed.
9 Now that the hood is assembled and the fabric is stretched tight,
it is a good practice to check the rubber gasket around the top
edge of the A
CCU
B
ALANCE
fabric. In order to achieve a good
straight alignment of the rubber gasket along the top of the frame
structure, you may need to peel back and re-attach small portions
of the Velcro surfaces.
10 Finally, at the corners, tuck the straight rubber gasket flaps under
the edges cut at an angle. This will create a virtually leak-free,
soft, pliant seal.