Tryton TOE3000, Operating Instruction

Page: 7 / 64

7
packaging to provide protection device is in sound technical condition.
against mechanical damage. Prior to commencement of the device
operation one has to tighten all the
WARNING! General warnings
loosened bolts, screws and nuts. Worn or
regarding the use of power
damaged parts shall be replaced with new
tools.
ones.
Repair :
c) Make sure that the device can be
switched off immediately under
emergency circumstances. Do never
use the device if it cannot be switched
on and off with use of the mains
switch.
Faulty switch must be handed over
for repair by a qualified technician.
d) Prior to starting operation of the
device one has to thoroughly inspect
the area where the machine is to be
used and remove all hard things that
m a y d a m a g e t h e c h o p p i n g
mechanisms used to disintegrate
swept material
(e.g. stones, tins, pieces of
glass, porcelain or metal).
e) Do not use the device to collect hot,
W A R N I N G ! G A R D E N
glowing or burning material (e.g.
VAC /BLOWER, supplementary
cigarette butts, glows of fossil) as well as
safety precautions:
do not target the blown air to such
a) The appliance can be used only when
things.
is fully assembled. It is not permitted to
f) Do not use the device nearby
operate the appliance by minors below the
flammable liquids or gases. Otherwise
age of 16. Also people who have not read
a hazard of a fire or an explosion may exist.
this User Manual and have not sufficient
g) Do never use the device at rain, poor
skills to use of the device are not allowed to
weather or in wet environment. Work
operate the machine.
only at daylight time or with very
b) To eliminate possible hazards to
good electric illumination.
operators it is mandator y to
periodically check whether the
h) The device can be used in the
a) Warranty and post-warranty repairs
of its power tools are carried out by
PROFIX Service, which guarantees the
best quality or repair and use of
genuine spare parts.
b) If a fixed power cord is damaged, to
avoid risks it should be replaced by
power tool manufacturer or in a
specialty repair shop or by a qualified
person.
WARNING!
While operating power tools it is
necessary to observe basic work
safety rules to avoid fire, electric
shock or mechanical injury.