11
CAUTION:
Remember to always disconnect the battery from the tool prior
MANUFACTURER:
to starting the cleaning operations and unplug the charger from the outlet.
PROFIX Co.Ltd.,
34
Marywilska Street,
03-228 Warsaw,
POLAND.
This appliance is in conformity with national and European standards as
well as with general safety guidelines.
NOTE:
In case of technical issues, contact an authorised technical service.
The charger may be cleaned exclusively with use of a dry cloth.
Any repairs are allowed to be carried out exclusively by qualified staff with
The tool must be stored in a place that is not accessible to children and
use of original spare parts.
must be kept clean and protected from moisture and dust. The storage
PROTECTION OF THE ENVIRONMENT:
conditions should prevent potential mechanical damage and impact of
NOTE:
The symbol nearby denotes that old equipment must
the weather conditions.
never be thrown away together with other waste (with the
TRANSPORTATION:
penalty of a fine).
Hazardous components of electronic
Store and transport the tool in its transport box to protect it against
equipment may adversely affect the natural environment
humidity, dust penetration and small objects; remember to protect its
and human health.
ventilation openings. Small objects after getting into the casing can
Each household may contribute to the recovery and reuse (recycling) of
result in damage to the motor.
old machinery and equipment. Both in Poland and Europe a system for
If the battery is removed for transport or storage, make sure the contacts
recovery of used equipment either exists or is being created. The system
will not short circuit. Remove metal items such as screws, nails, clasps,
obliges all organizations that sell such equipment to collect the used
loose bits, wires, or metal filings from the case or transport container or
machinery and appliances. Moreover, general purpose collecting points
otherwise prevent them from touching the battery.
for such equipment are available.
Clean dirty parts and ventilation openings with a brush after use. Clean
the housing and plastic parts with a mild detergent and a damp cloth.
Prevent water from penetrating the inside of the device. Do not use
aggressive cleaning agents or solvents for cleaning!
TROUBLESHOOTING GUIDE:
PROBLEM
POSSIBLE CAUSE
REMEDY
Irregularities of the motor
operation.
Worn carbon brushes of the motor. Have the brushes replaced at a service workshop.
The grass trimmer does not
work.
No power voltage, damaged
motor or the power trigger.
Check the battery status, recharge or replace with a new one when necessary.
When the problem persists hand over the tool for repair at a service workshop.
Please refer to the warranty sheet for addresses of authorized workshops.
Battery low.
Recharge the battery.
The policy of the PROFIX company consists in permanent improvements of the offered products and therefore the
company reserves the right to make amendments to the product specification without a prior notice. The images
included into the operation manual are only of the exemplary nature and may slightly differ from actual appearance of
the device purchased.
This
instruction
manual
is
protected by copyright.
Copying it
without the written consent of PROFIX Co. Ltd. is prohibited.
Summary of Contents for TJB110
