10
charging. Blinking green battery LEDs also indicate that the battery is
charging and show the current battery level.
When the battery is fully charged, the red LED goes off and the green LED
Grass trimming
is on.
Do not trim wet grass. Trim dry grass for the best results.
After charging, disconnect the charger and remove the battery.
Hold the trimmer at 20° and swing it left and right. Make sure to keep the
NOTE!
The battery may get slightly hot when charging. This is not a
device far from your body.
malfunction.
Only grass not taller than 15 cm can be trimmed effectively. Higher grass
The lithium-ion battery can be charged at any moment, without
should be trimmed in a few passes, starting from the top.
detriment to its life. Interrupting the charging process does not entail a
Do not approach hard objects with the trimmer not to increase line
risk of damaging the battery cells.
consumption excessively.
n
Using the adjustable handle
n
Trimming around shrubs and trees
The adjustable handle (
5
) can be set to various positions:
Be particularly careful when trimming grass around shrubs and trees. Do
To change the position, loosen the lock knob (
6
) and move the
not touch them with the trimmer line. Bark damage can cause wither.
adjustable handle (
5
). Tighten the lock knob to secure the handle in
The plant protector (
12
) makes manoeuvring easier by preventing the
place
(
).
line from touching tree bark.
n
Adjustment of the length of the telescopic shaft
The length of the grass trimmer can be adjusted to your height with the
telescopic shaft (
9
)
:
NOTE:
Disconnect the battery before replacing the trimming
component! Use only spare parts and accessories
ź
Hold the telescopic shaft (
9
) with one hand and UNLOCK the lock ring
recommended by the manufacturer.
(
8
) as shown by the arrow.
(
,
3
).
1.
Switch the trimmer off and wait for all parts to stop moving.
ź
Slide the shaft to the right length and LOCK it by turning the lock ring.
2.
Remove the battery.
n
Moving the trimmer head
3.
Remove the spool holder (
15
) from the trimmer. To do this, hold the
1
Press the release button
(
7
) (
,
3
).
outer part of the spool holder base (
23
) and press the spool holder
2
Rotate the telescopic shaft (
9
) by 180°, to set the trimmer head (
11
) in
release buttons (
26
) with the other hand at the same time. Rotate the
the vertical trimming position (or for edge trimming), and release the
spool holder as indicated by the REMOVE arrow
(
,
4
)
.
button to lock the head in place.
The spool cover (
25
) and spool (
24
) can be disassembled easily now
n
(
,
4
)
.
NOTE:
There is a spring in the base, which can
become lost quickly. Make sure it is stored safely.
4.
Select
OPTION 1
or
OPTION 2
below to replace the spool or line.
(
,
3
)
OPTION 1: SPOOL REPLACEMENT
1.
Use a replacement spool.
2.
Thread the line (
21
) through the eyehole in the spool cover (
25
) and
slide the spool in (
24
)
(
,
4
)
.
3.
Make sure the spring is in, install the spool and spool cover back into
the spool holder base (
23
) To do this, press the spool holder (
15
) and
rotate it right until it locks
(
I2
,
4
)
.
4.
To check whether the line slides correctly, press the spool button (
20
)
with your thumb and pull the line (
21
) with your fingers at the same
time
(
,
3
)
.
The line should slide freely.
OPTION 2: LINE REPLACEMENT
(
,
4
)
The trimmer line can be purchased from your local distributor. To install a
line:
OPERATION:
1.
Thread about 3 mm of one end of the line (
21
) through the spool
n
Switching the trimmer on and off
opening (
24
)
(
K
,
4).
NOTE!
The trimmer can be started in the operating position
2.
Carefully rewind the line onto the spool evenly as indicated by the
only with the rotor near the ground and the user holding their
arrow on the spool until the line reaches the dents on the edge of the
hands on the main and adjustable handles.
spool. Do not wind an excessive amount of line. The spool can hold
The trimmer has a safety button (
4
) to improve safety. It prevents
about 6.5 m of line.
accidental activation of the tool.
ź
To start the device, press the safety button (
4
), hold it down, and press
the on/off switch (
2
)
(
A
,
2)
ź
To switch it off, release the on/off switch
(
2
).
OPERATION GUIDELINES:
n
ź
see Fig.
A1
,
page
2
REPLACEMENT OF THE TRIMMING COMPONENT:
see Fig. page
.
see Fig. page
.
see Fig.
page
see Fig. page
NOTE:
Disconnect the battery before adjusting the line.
To extend the line, press the spool button (
20
) and at the same time, pull
the end of the line (
21
) see Fig. page
.
When the trimmer is started, the excess length of the line is cut by the line
cutter (
22
) on the safety guard.
n
Automatic adjustment of the trimmer line
see Fig. page
If the line gets damaged during operation, press the trimmer vertically
into hard ground to activate the spool button (
20
) with the motor
running. The centrifugal force will pull the line from the spool. It will be
see Fig. page
cut to the right length by the cutter on the safety guard.
n
Trimmer angle adjustment
ź
The trimmer angle can be adjusted to four positions. To do this, press
see Fig. page
the trimmer head release button (
10
), set the angle and release the
button
see Fig. page
.
see Fig. page
see Fig. page
Generally, the machine does not require special maintenance. To ensure
safe and efficient operation, clean the device immediately after each
use.
Store the trimmer out of the reach of children when not in use.
F
F
I1
Manual adjustment of the trimmer line
J
G
J
G
H
MAINTENANCE AND STORAGE:
After use, disconnect the battery and check the trimmer for damage.
Summary of Contents for TJB110
