TRW TA S40 Series, Service Manual

Page: 52 / 60

Page 1-52 TRW TAS STEERING GEAR DocID
STEERING GROUP 0603-V-003-0207
File Last Modified: September 17, 2012 10:18 am
51
Tools Required
Press
J37071-A (TAS65 Step Bore gear)
Materials Required
Roller Bearing - Step Bore
Remove roller
bearing if required
1. If roller bearing (49) in housing needs to be replaced, place the
bearing removal end (long end) of the bearing and seal tool
against the trunnion end of the bearing and press it out of the
side cover end of the bearing bore. Discard bearing.
J37071-A
Press
Press in housing
roller bearing
2. Press the roller bearing into the housing from the side cover end
of the bearing bore until it is seated against the step bore. Be
sure the housing is square with the press base and the bearing
is not cocked.
Use the bearing installation end of
the tool (short end). If the bearing
removal end of the bearing & seal tool is used to press
in bearing, the cage on the new bearing may be
damaged.
J37071-A
Press
If the unmachined trunnion face is not
square, use shims to square it before
pressing in the bearing.