14
Installing the OCB transfer device
1714400_ANGLE_MEAS
URING_SYSTEM_OCB
The right yellow LED of the radio measured value transfer device is
lit. The control waits for the angle measurement. The actual angle
is transferred and this LED goes out.
Transfer of the measured angle
All angles have been measured and successfully transferred. The
measured angles have to be confirmed by being accepted before
the Y1 corrective value and the Y2 corrective value are then
calculated from them. These corrective values are then saved in
the bending program. This input mask disappears and all LEDs are
then off, since no further input field has been selected for the
measure angle.
Fig. 49855
