16
Installing the OCB transfer device
1714400_ANGLE_MEAS
URING_SYSTEM_OCB
Global corrections
By focusing of the correction field in the global corrections mask
and selection of the appropriate nominal angle, all position LEDs
are automatically controlled at the OCB radio transfer device. In
this way, it is shown that the angle to be measured has no clearly
defined position assignment. The measured angle is then
automatically taken over into this field as correction and all the
position LEDs flash as confirmation several times briefly. All
nominal angles in this bending program with the displayed angle
value now receive this transferred corrective value.
Global corrective value for all 90° angles
Note
The goniometer has to be set to degree 0°0´/0.00° with the button.
It is so that the degree units as well as minutes and seconds can
not be determined via the goniometer interface. The direction of
rotation from the adjustable side [(3) Fig. 49846] has to be set in
such a way that the goniometer counts positively upwards in the
clockwise direction.
Fig. 49858
