1714400_ANGLE_MEAS
URING_SYSTEM_OCB
Installing the OCB transfer device
7
The OCB USB stick can, in principle, be plugged into any
USB plug socket of the machine control. However, USB plug
sockets outside the switch cabinet should be selected since
a closed switch cabinet significantly impedes radio signals.
The cap protects the plug from contamination. It is taken off
before plugging in and can then be put on again at the rear
for storage purposes during use.
Registering the OCB transfer device at the
OCB USB stick
Before delivery, all OCB systems are already paired. Every
OCB transfer device is already assigned in the factory to the
respective supplied OCB stick. For this reason, the
registering of the OCB transfer devices to OCB USB sticks
by the user is only necessary if new arrangements between
OCB transfer devices and OCB USB sticks are to be
established.
Up to 16 OCB transfer devices can be assigned to one OCB
USB stick. An OCB transfer device can be registered to
more than one OCB USB stick. The machine controls do not
participate in this registration procedure.
DELEM machine control
TruBend Series 3000
Note
Angle transfer by OCB for DA65TW control
is not possible.
Prerequisite for angle transfer by OCB
T3000 with software version
≥
V1.2.32.
Fig. 49845
