Trumpf TKF 104 - 1, Operator'S Manual

Page: 6 / 12

4
GB
TKF 104 - 1 E254en1_02.doc
Cooling and lubrication
The cutting results are improved and the service life of
the cutting tool is increased if
•
before machining the workpiece
the cutting track is coated with oil.
Recommended for steel:
Punching and nibbling oil, order no. 103387
Recommended for aluminium:
Wisura oil, order no. 125874
Working with the machine
Damage to property
Turn on the machine before beginning to cut
the sheets.!
•
Put the machine on the sheet and leave a few
centimetres clearance between the cutting tool
and the edge of the sheet.
•
Turn on the machine and push it against the edge
of the sheet as far as possible (piercing).
•
Push the machine along the sheet so that the
machine axle is approximately parallel to the
sheet edge. Press the machine against the sheet
edge.
Sheet thickness
Fig. 11408
•
Place the machine on the sheet (working
position).
•
Unscrew the clamping screw (54).
•
Adapt the rest plate (45) to the sheet thickness
using the spindle (47). In doing so, leave 0.5 to
1 mm play.
•
Tighten spindle (47) with clamping screw (54).
Fig. 11408
Setting the length of the bevel set
•
Unscrew the set screw (41).
•
Set the stripper (40) in such a way that the
desired length of the bevel (dial scale on
supporting body 52) corresponds to the reference
edge B.
•
Attach the set screw (55) lightly in this position
and then tighten set screw (41).
Fig. 10980
45
54
52
47
45 Rest plate
47 Spindle
52 Supporting body
54 Clamping screw
55
41
40
B
43
54
47
45
52
40 Stripper
41 Set screw (tightening)
43 Wearing plate
45 Rest plate
47 Spindle
52 Supporting body
54 Clamping screw
55 Set screw (supporting)
B Reference edge