E254en1_02.doc
TKF 104 - 1
GB
9
Check the wear on the cutting tool guide in the
stripper (40)
See Fig. 14194
The stripper (40) must be replaced if the clearance
between the stripper and the cutting tool is greater
than 0.3mm.
Checking and replacing the wearing plate
See Fig. 14194
•
Remove the supporting body (52).
•
Check the wearing plate (43) for scratching
marks; if the running surface has been worn
down approx. 0.2mm (see outer ring = "wearing
mark", the wearing plate must be removed by
levering it out with two screwdrivers and turned
or replaced.
Fig. 14194
Cleaning
Clean the filter 355 every 10 operating hours in order
to prevent throttling or power loss.
See the spare parts list for an diagram of
filter 355.
Speed limiter and ball bearing are to be lubricated
with gear grease during regular machine mainte-
nance.
Warning:
Speed limiter 324 is to be handled with
particular care, as damage can cause overspeed.
See diagram in the spare parts list.
Changing vanes
The performance of the machine decreases if the
vanes are excessively worn.
Vane replacement and all other repair work is to be
carried out by an expert!
Vane set (4) on the rotor of the compressed-
air motor. See Item 310 in the spare parts
list for corresponding diagram.
Repairs
Danger of injury
Pneumatic tools conform to the applicable
safety regulations. Repairs may only be
carried out by qualified electricians in order
to prevent unnecessary accidents.
Use only o r i g i n a l s p a r e p a r t s.
Please note the specifications on the output plate.
You will find a list of TRUMPF
representatives at the back of this operating
manual.
40
52
43
S
40
Stripper
43
Wearing plate
52
Supporting body
S
Grease nipple for lubrication of cutting tool guide with a
grease gun (order no. 068624)
Summary of Contents for TKF 104 - 1
Page 1: ...Operator s manual english TKF 104 1...
Page 2: ......
