CHAPTER 2: ASSEMBLY INSTRUCTIONS
TREADMILL ASSEMBLY STEPS (continued):
STEP 3-A Frame Cable Connections:
*110 Volt Units ONLY
a
) Connect the
CNTRL
cable to the
smart board as shown.
NOTE
: The
AUXPS
cable attached to
the
CNTRL
cable is not used for this
installation
STEP 3-B Frame Cable Connections:
*220 Volt Units ONLY
a)
Cut the wire tie holding the female
end of the
AUXPS
cable to the
CNTRL
cable as shown.
b
) Connect the female end of the
AUXPS
Cable coming from Pedestal
to
AUXPS
Cable coming from the
pre-installed power supply brick.
c
) Connect the CNTRL cable to the
smart board as shown
NOTE
: The male end of the
AUXPS
cable wire tied to the
CNTRL
cable is
not used for this installation.
AUXPS Connection
Made
Make CNTRL
Connection Here
Make CNTRL
Connection Here
Cut Wire Tie
Truefitness.com / 800.426.6570 / 636.272.7100
12