38
8.4 GRINDING THE TERMINALS
1. On the LCD operation panel, longitudinal
grinding mode (Longitudinal) is automatically
recognized.
Check if the cutting button is activated.
Activated
Deactivated
If it is not activated, touch the
Cutting
Button
→
It will switch to green (activated)
2. Press
START
button.
※
After changing the grinding wheel, press and
hold
START
button for approx. 3 seconds or
longer to activate the longitudinal cutting mode.
From the 2
nd
time, you only need to press
START
button.
3. The terminal will move a certain distance to the
left, while the grinding wheel starts rotating.
At this position, operators will control the LCD screen to move the terminal close the wheel
a little at a time.
Check the camera while moving the terminal:
a. Press and hold button to move the terminal close to the grinding wheel
b. When the terminal is about touching the wheel, release the button.
c. Next, press
button once at a time.
Each time pressing this button, CS07 will move the terminal a certain distance to the left.
※
This distance is displayed below this button.
When the terminal starts touching the wheel, you will hear a grinding sound.
Wait until this sound disappears, then press
button again to move it further to the
left.
→ The grinding sound appears again.
Wait until this sound disappears before pressing the
button again. Keep doing it
until it reaches the measuring position.
