Z:\Build\Pet Stock\Pet Stock Twin Operators Manual Aug 2020 v7.0.docx
© Tru Blu Dog Wash 2016
10
Perform a final verification that the assembled dog wash is level as this will ensure best
operation.
ENSURE all doors open and close freely before securing the Dog Wash!
Once the Dog Wash is level, use the supplied spacer washes and anchor screws to secure
the Dog Wash to the ground.
2.2 Connecting the Water Supply and Waste connection to the Dog Wash.
Before connecting the Dog Wash to Water and Waste ensure local regulations are
considered. Please refer to the installation manual for more detail.
2.2.1
Connecting the Water Supply
Flush the pipes prior to connecting to the DOG WASH. Maximum allowable inlet water
pressure is 72psi (0.5mpa / 500kpa).
The picture at left shows the hot and cold-water entry points for a K9000 Twin without an on-
board hot water unit. While the picture on the right shows the water entry point for a K9000
Twin with an on-board hot water unit.
Cold water
connection
Hot water
connection
Cold water
connection
HW unit
