Z:\Build\Pet Stock\Pet Stock Twin Operators Manual Aug 2020 v7.0.docx
© Tru Blu Dog Wash 2016
7
2 Installation
The K9000 Twin Dog Wash (Dog Wash) can be installed either indoor or outdoor.
Caution should be taken when the Dog Wash has been delivered and is
being unloaded. The K9000 Twin Dog Wash is delivered in two parts with a total weight of
approximately 350kg. The larger of the two parts weighs approximately 260kg and
measures 2100mm in length, 1850mm in height & 600mm in depth. The smaller of the two
parts weighs approximately 90kg and measures 1500mm in length, 1850mm in height &
600mm in depth.
Ensure a qualified operator of the unloading equipment is used to lift or move the Dog Wash.
Inspect the Dog Wash when you receive it to ensure there is no damage. If there is any
damage, please contact Tru Blu Dog Wash before accepting it.
Each of the two parts of the Dog Wash (Within Australia) are first bubble wrapped and then
wrapped in black plastic cargo wrap. They are secured to individual pallets with a tie down
strap over the cabinet and 6 screws (4 screws for the smaller part).
Position the Dog Wash while on the pallets near their final location. The larger section of the
Dog Wash goes to the left-hand side, with the highest point being the back of the Dog Wash.
Take caution removing the plastic and bubble wrap avoid using a knife as it may scratch the
stainless steel or decals. With a screw gun remove the screws from the feet and the tie down
straps.
Inside the cabinet you will find an Install Pack, open and verify the parts against the check
list. There will also be an operator’s manual, product MSDS’s and product order forms in a
purpose built sleave within the cabinet.
