1mm
Rudder
Tailing
edge
Cut away the rubber tube when
the epoxy glue dried.
Make sure they are in
the right position while
installing.
Keep some space about 1mm width between
the tailing edge and the rudder.
Drill holes to the relevant position in the tailing edge
and epoxy the rudder to them.
2.5mm
3mm
30mm
90mm
75mm
2
Plastical tube(3x30mm)
2
Steel wire (0.5x3000mm)
2
2
2
Clevis
Washer(3x15mm)
Lock Nut (3mm )
1
Screw (3x80mm)
2
Copper joiner
Washer(3x15mm)
Screw (3x80mm)
Lock Nut (3mm )
Clevis
Aluminum tube
Steel wire
The sketch map after the rudder shaft assemble finished.
The sketch map of the linkage for the rudder
and the tail wheel.
2
2
Clevis
Copper joiner
2
2
Screw (2x10mm)
Nut (2mm )
2
Washer(2x5mm)
Steel wire
Copper joiner
Lock Nut (2mm )
Screw (2x10mm)
Ball joint
Washer(2x5mm)
Install the servo.
Drill a small hole to appropriate position in the fuselage
for installing the plastical tube and a hole in the rudder
for assembling the rudder shaft.
50
51
53
54
10
49
52
Mount the fuel tank to the fuselage.
Note: Customers can choose nylon stabbing fix the tank,
We don’t suppty nylon stabbing.
Linkage Stopper
Washer (2mm)
Washer (2mm)
Nut (2mm)
Set screw (3x4mm)
Washer (2mm)
Set screw (3x4mm)
1
1
1
1
Install the servo.
Assemble the throttle servo to appropriate
position in the fuselage.
B'
A
A'
B
Make sure to glue securely.
If not properly glued, a failure in flight may occur.
Temporarily fasten down the main wing and
check its correct position.
Securely glue together.If coming off during flights,
you'll lose control of your airplane which leads
to accidents!
A = A '
B = B '
2
Steel wire (0.5x3000mm)
1
U-style wire (150x25mm)
Pin hinge(24x24mm)
6
4
Matal douel (4x30mm)
1
Rib template (2mm ply)
1
Stab joiner (12x310mm)
Assembly of the stabilizer.
Set the U-style wire through the enlargd hole as below.
2
1
Steel wire (0.5x3000mm)
U-style wire (150x3mm)
2
2
Clevis
Copper joiner
2
2
Screw (2x10mm)
Nut (2mm )
2
Washer(2x5mm)
2
Plastical tube(3x30mm)
35
37
36
33
34
7
Accessory list for the coming installation steps.
