: 4-cycle .91
14
"
x7
6
(with 13 servos),
6
6
6 channel radio for aiplane is highly recommended for this model.
Warning
Remove the covering with proper
pressure to cut through only the covering itself.Otherwise,
cutting down into the balsa structure may weaken the
model part and cause accident.
The pre-covered film on ARF kits may wrinkle due to
variations of temperature.Smooth out as explained right.
Apply
Pre-cover the covering with clean cloth!
Start at low setting. Increase the setting if
necessary.If it is too high,you may damage
the film.
Iow setting
with cover(cloth)
3.25 in Spinner
Screw (2x10mm)
Washer (2x5mm)
Nut (2mm )
Washer (2x5mm)
Entad
8
Screw (2x10mm)
Washer (2x5mm) 16
8
Nut (2mm )
155mm
2mm
40mm
150mm
4
4
Hatch hinges
Hatch hinges mount
5mm
The illustration for assembing the hatch hinges
and hatch hinge mounts.
Trim the shaded portion so that the bend cutting not
be blocked when the landing gear down.
The front view when the landing gear up.
The sketch map when the model assembly completion.
Mark the position in the landing gear cover and side
fuselage for hatch hinges mount and hatch hinges.
Assemble the hatch hinges and hatch hinges mount
with screw ,washer and nut.
12
13
14
15
21
11
16
