Securely glue together. If coming off during flights, you 'll
lose control of your airplane which leads to accidents!
Make sure hinges are
mounted in the same line.
6
Pin hinge(24x24mm)
1mm
Rudder
Tailing
edge
Make sure they are in
the right position while
installing.
A=A’
Make sure they are in
the right position while
installing.
A
A’
Securely glue together. If coming off during flights, you 'll
lose control of your airplane which leads to accidents!
Apply instant type CA glue to rudder and pin hinge.
Assmble the elevator to the stabilizer with CA gule and
the metal wire with epoxy glue.
Keep 1mm width space between horizontal tail and
rudder.
Assemble the rudder to the vertical tail with CA glue.
Cut off the surplus portion from the vertical tail carefully.
Epoxy the vertical tail to the stabilizer.
50
52
53
54
55
10
51
Clevis
Retainer
Rod (2x300mm)
Screw (2x10mm)
Make sure to glue securely.
If not properly glued, a failure in flight may occur.
Temporarily fasten down the main wing and
check its correct position.
Securely glue together.If coming off during flights,
you'll lose control of your airplane which leads
to accidents!
A
A’
B
B’
A=A’
B=B’
31mm
28.6mm
30mm
3mm
Rod (2x300mm)
Clevis
Washer(3x15mm)
Washer
Lock Nut (3mm )
Screw (3x35mm)
1.5mm
Screw (2.3x12mm)
The standard sketch map will be as below when
the horizontal tail install completion.
Install the medium servo as below.
Install the nylon control horn and connect the
linkage.
The position of the control horn in the rudder.
Secure the servo,install the nylon control horn
and connect the linkage.
The illustration for how to assemble the control horn.
57
58
56
60
59
11
61
Polish the surface flat.
