Rod (2x300mm)
Clevis
Washer(3x15mm)
Washer
Lock Nut (3mm )
Screw (3x45mm)
Retainer
3mm
6mm
2
Wood dowel (6x50mm)
97mm
6mm
97mm
7.2mm
Blind Nut
35mm 120mm
Screw(6x50mm)
2
Screw(6x50mm)
Reinforcement Plate
Reinforcement Plate
2
Epoxy the dowel on the leading edge of wing.
Assemble the arms in the flaps the servo arms to them
with rods as below.
Trim two holes to pull the servo extension
lines and fuel tube from the holes.
200mm
50mm
Center
line
2
Blind Nut (6mm)
Drill holes in the fuselage for installing the wings.
Drill holes in the appropriate position through the wing
to fuselage,set blind nut in the fuselage.
Put the reinforcement plate on the holes and fix the
wings to the fuselage with screws as illustration.
17
18
19
20
16
4
21
12
TP Screw (2.3x8mm)
Ply (15x15x3mm)
12
1.5mm
TP Screw (2.3x8mm)
Epoxy plies inside the fuselage under the cowing and
mount the cowing with TP screw as illustration.
2
Dummy flap
15mm
45mm
3mm
4.2mm
Blind Nut
1
1
Wooden Block(66x60x9mm)
Wooden Block(66x60x9mm)
Epoxy plies under the canopy and assemble the
canopy to fuselage with screw.
Trim slots in right position in the bottem wing.
70mm
100mm 123mm 123mm
Epoxy the dummy flaps to the wings.
3mm
Epoxy the dummy parts to the appropriate position
in the mid wing.
Epoxy the wooden block to the appropriate position in the
fuselage,drill holes through the the wooden block from the
dummy fairing and set blind nut in the big hole as illustration.
Epoxy the fairing part to the fuselage.
fairing part
2mm
16mm
66
65
13
69
67
70
68
