Washer (4x8mm)
Washer (4x8mm)
Screw (4x35mm)
Screw (4x25mm)
Nut (4mm)
Spring Washer (4mm)
4mm
4
Blind Nut (4mm)
1
Engine mount (68x105mm)
Linkage Stopper
4
4
12
4
Washer(4x8mm)
Screw (4x35mm)
Spring Washer (4mm)
Nut (4mm)
2
4
Screw (4x25mm)
2
Plastic tube (2x400mm)
Fuel tank (550cc)
1
157 mm
In case of 2-cycle & 4-cycle engine.
Assemble the engine.
5.2mm
Blind Nut
4
Blind Nut (4mm)
Collar
Collar
Tail landing gear
6
TP Screw (2.3x8mm)
Ply (15x15x3mm)
6
TP Screw (2.3x8mm)
1.5mm
Epoxy plies to appropriate position in the fuselage.
Then assemble the wheel as illustration.
Collar (3mm)
2
2
o
Tow degree downthrust
Ply
The front view of the engine install completion.
The side view of the engine install completion.
Drill four holes at the diameters as shown
for engine mount.
50
51
52
53
10
Accessory list for the coming installation steps.
49
C = C '
D = D '
Make sure to glue securely.
If not properly glued, a failure in flight may occur.
Temporarily fasten down the main wing and
check its correct position.
Securely glue together.If coming off during flights,
you'll lose control of your airplane which leads
to accidents!
C
D
C'
D'
1mm
Elevator
Make sure they are in
the right position while
installing.
Trailing
edge
Securely glue together. If coming off during flights, you 'll
lose control of your airplane which leads to accidents!
2x20mm
2
2
Clevis
Copper joiner
2
2
Screw (2x10mm)
Nut (2mm )
2
Washer(2x5mm)
Steel wire
Copper joiner
Lock Nut (2mm )
Screw (2x10mm)
Ball joint
Washer(2x5mm)
Install the nylon control ring for switch and
connect the linkage.
Assemble horizontal tail, vertical tail,
tail gear separately.
Keep some space about 1mm width between the
elevator and horizontal tail edge.
Glue the elevator to the stabilizer by CA and epoxy.
Assemble the elevator servo to the appropriate
position in the fuselage.
The sketch map for the wires of elevator servo
in the fuselage.
33
32
34
36
7
37
35
Accessory list for the coming installation steps.
