1
1
Tail landing gear(3mm)
Tail wheel (45mm)
TP Screw(3x10mm)
2
6
TP Screw (2.3x8mm)
Ply (15x15x3mm)
6
1
1x20mm
3x6mm
Ply3mm
1.5mm
TP Screw (3x10mm)
3x10mm
25mm
50mm
1
1
Pin hinge
Pin hinge
Metal arms
2
Steel wire (0.5x3000mm)
Pin hinge
3
1
Wooden Block (3mm Ply)
Wooden Block (3mm Ply)
Wooden Block (3mm Ply)
Collar (3mm)
2
Washer (3x6mm)
2
Washer (3x6mm)
The sketch map when assemble the tail landing
gear to the wheel steeling mount.
Tail landing gear(3mm)
Let the tail landing gear go through the fuse tail until to
the proper position,and cut off the surplus parts of the
landing gear as illustration.
Epoxy a wooden block to inner fuse tail for helping
fix the landing gear mount.
Trim a slot in the vertical fin for epoxying the pin hinge
of tail landing gear in it.
Fix the tail landing gear mount with TP screws.
Tail landing gear mount
Tail landing gear mount
38
39
42
8
40
41
Accessory list for the coming installation steps.
1mm
Rudder
Tailing
edge
Cut away the rubber tube when
the epoxy glue dried.
Make sure they are in
the right position while
installing.
Pin hinge
3
Make sure hinges are
mounted in the same line.
25mm
49mm
49mm
2.5mm
Epoxy pin hinges to rudder.
2.5mm
2
2
Clevis
Copper joiner
2
2
Screw (2x10mm)
Nut (2mm )
2
Washer(2x5mm)
Steel wire
Copper joiner
Lock Nut (2mm )
Screw (2x10mm)
Ball joint
Washer(2x5mm)
3mm
Rudder servo
Rudder servo
Elevator servo
Elevator servo
2
Steel wire (0.5x3000mm)
Drill holes to appropriate position in the vertical tail
and epoxy the rudder to the vertical tail steadily.
Epoxy the pin hinge to the rudder steady.
Install the rudder servo.
Install the rudder servo in the fuselage.
The sketch map of the steel wires run through
in the fuselage.
44
45
46
47
48
9
43
