General Information
Jamara e.K. is not liable for any damage caused to the product itself or through this, provided this
is due to improper operation or handling errors. The Customer alone bears the full responsibility for
the proper use and handling, including without limitation, the assembly, the charging process, the
use and choice of the operation area. Please refer to the operating and user instructions, it contains
important information and warnings.
Attention!
In some countries it is a legal requirement to carry third party indemnity insurance when operating
a radio controlled model. Please ask your local dealer, governing body or your insurance company
for details.
This model is not a toy!
Suitable for people over 14 year.
Warning:
Not suitable for children under 36 months.
RISK OF SUFFOCATION.
Contains small parts which can be swallowed. Keep away necessarily from children
No. 006143
Fokker DVII
GB - Instruction
Box contents:
• Modell • Wheels • Undercarriage • Accessories • Instructions/Planes
Functions:
• Aileron • Elevator • Vertical fin • Throttle
Highlights:
• Fuselage made of balsa and plywood • Wings made of wood in rib construction
• Wooden construction kit • Ideal to have with you at all times • Laser cut kit
Recommended accessories
Electric motor
A2820/6
No. 13 2820
Propeller AEJ
10 x 7
No. 34 0124
Servo
High End 929 HMG
No. 07 4420
Technical data:
• Wing span: ~ 1200 mm • Length: ~ 990 mm
• Wing area ~ 41 qdm • Weight: ~ 1400 g • Servos: 4 x 13,6 g
• Battery LiPo 14,8 V 2200 mAh • Motor 1000 KV 550 W
No responsibility is taken for the correctness of this information. Subject to change without prior
notice. Errors and omissions excepted
TOP MAIN WING ASSEMBLY
Recommendation: Try to find a flat surface planking (L:1200 mm; w:400mm) or glass as working table for the following steps.
Place the W3 and W2 on the working table and the slot part
upward.
Try to place the 3mm wide of W3 on the bottom of the W2. Use
triangle ruler when apply instant glue to secure the W3 on the
W2.
Close view after glue. The slot part must be upward. The angle
between W2 and W3 is 90 degree.
Try to find the 2 pieces of W11 and one piece of W12 from the
laser-cutting parts bag and place them on the working table.
Apply UHU glue to secure the W11 on both sides of W12. Use
clip to hold them together until the glue is dried enough. Make
sure the combination remain aligned. Drop some instant glue on
the edges. Repeat the same steps for another combination.
Refer to the assemble drawing; try to fit the W2 and W4. Don‘t
apply any glue on them. Try to fit the W15 and drop very small
amount of instant glue on the joint place. Fit the rib W6 from
the center part. Fit other ribs W7, W8, W8, W7, W9, W10, W12,
W13, W14 in order.
Summary of Contents for Fokker DVII
Page 16: ...16...
Page 17: ...17...
Page 27: ...27 Ailerons Elevator Rudder Installation of Electrical...
