Jamara Fokker DVII, Instruction

Page: 8 / 28

8
Place V2, V3, V4, V5, H5 on the working table for assembling
elevator.
Try to fit V4 into V2; fit H5 and V5 into V3. Use instant glue to
secure V4, H5 and V5 in place.
RUDDER ASSEMBLY
Use sanding paper to trim the top edge into round edge.
Close view of the round edge.
Use wooden planning tool to trim the leading edge of the V3 into
V shape (30 degree).
Use sanding paper to trim the outer edge of the rudder into round
edge (R5).
Remove the rudder from the fuselage. Use 2mm driller to drill
24mm depth hole on the marking position.
Close view of the V shape.
Close view of the round edge.
Use hobby knife to cut a V slot from the drilling holefor installing
tail gear.
Try to fit the V2 into V3 and use instant glue to secure them in
place..
Use hobby knife to cut the hole on the rudder for inserting hinges.
The location for the hole is 10mm from the top and 35mm from
the bottom.
Try to fit the tail gear into the V slot.
Use sanding paper to trim the surface of the rudder. The thick
-
ness is 5mm; don‘t trim too much.
Try to fit the rudder into the fuselage. Insert the tail gear to the tail
and use marker to mark the top of the wire on the rudder.