4mm
2
1
Steel wire (0.5x3000mm)
U-style wire (150x3mm)
1
Stab joiner (12x280mm)
4
Wood dowel (4x30mm)
1
Rib template (2mm ply)
6
Pin hinge(24x24mm)
4mm
Rib template (2mm ply)
Stab joiner (12x280mm)
1
Rib template (2mm ply)
1
Stab joiner (12x280mm)
4
Wood dowel (4x30mm)
Wood dowel (4x30mm)
Rib template (2mm ply)
6
Pin hinge(24x24mm)
3mm
1
U-style wire (150x3mm)
U-style wire (150x3mm)
2
Steel wire (0.5x3000mm)
2
2
Clevis
Copper joiner
2
2
Screw (2x10mm)
Nut (2mm )
2
Washer(2x5mm)
Set the U-style wire through the tail of fuselage as
below.
According to the rib template drill holes
in the stabilizer and fuselage!
Drill holes in the stabilizer root base on rib template
and epoxy the wood dowel in them.
According to the rib template drill holes to the tail of
fuselage as below.
Epoxy the horizontal to fuselage and take care to
keep all the surface clean.
Glue the pin hinges to the elevator and trim slot in the
right position for fitting the U-style wire.
27
28
29
30
31
6
Accessory list for the coming installation steps.
Linkage Stopper
Washer (2mm)
Washer (2mm)
Nut (2mm)
Set screw (3x4mm)
Washer (2mm)
Set screw (3x4mm)
1
1
1
1
Fuel supply line
Fuel spray line
Air pressure line
Mount the fuel tank into the fuselage.
Assembly of the fuel tank.
Assemble the servos and switch .
Assemble the servo to fuselage.
Fuel tank (550cc)
1
Set Screw (3x4mm)
Set Screw (2mm)
Rod (2x400mm)
Set Screw (2mm)
Washer (2mm)
Linkage Stopper
1
1
1
1
1
4
4
Washer (4x8mm)
4
Rod (2x400mm)
Blind Nut (4mm)
Screw (4x25mm)
Set Screw (3x4mm)
Assemble the throttle linkage.
Install the engine.
55
56
58
59
11
54
57
