EN
9
gas heater fan TGH 11 E / TGH 16 E / TGH 31 E
1. First connect the pressure reducer to the gas cylinder. To
do so, screw the union nut of the pressure reducer in a
counter-clockwise motion onto the thread of the gas
cylinder.
2. Connect one end of the gas hose to the pressure reducer.
For this purpose, screw the union nut of the gas hose onto
the external thread of the pressure reducer by turning it
counter-clockwise. Use an open-end wrench of size SW 17
or SW 19 to do so.
Please note that the gas hose must not be kinked or
twisted.
3. Remove the protective cap from the hose connection at the
device.
4. Connect the other end of the gas hose to the hose
connection of the device. For this purpose, screw the union
nut of the gas hose onto the gas connection of the device
by turning it counter-clockwise. Use an open-end wrench
of size SW 17 or SW 19 to do so.
Start-up
Info
Odours might arise upon initial start-up or after a
longer period of non-use. There might be a passing
smell of burnt material.
A smell of gas however indicates a leak at the gas
connection that must be remedied immediately.
Otherwise there is an explosion hazard!
A number of spatial and technical conditions have to be
considered for the selection of the device's installation site.
Non-observance may impair the proper functioning of the device
or the accessories or can entail risks of personal injury and
property damage.
Only use the device in rooms corresponding to the minimum
dimensions specified in the Technical data chapter. When
positioning the device, observe the minimum distance from
walls or other objects as described in the Technical data
chapter.
2 m
3,5 m
2 m
2 m
2,5 m
