EN
7
gas heater fan TGH 11 E / TGH 16 E / TGH 31 E
TGH 31 E
1
2
3
7
6
5
4
Accessories
TGH 11 E
/
TGH 16 E
/
TGH 31 E
8
9
No.
Designation
1
Transport handle
2
On/off switch
3
Gas valve push button
4
Gas hose connection
5
Air inlet
6
Ignition button (piezo igniter)
7
Air outlet
8
Pressure reducer
9
Gas hose
Transport and storage
Note
If you store or transport the device improperly, the
device may be damaged.
Note the information regarding transport and storage of
the device.
Transport
To make the device easier to transport, it is fitted with a
transport handle.
Before
transporting the device, observe the following:
•
Switch off the device.
•
Hold onto the mains plug while pulling the power cable out
of the mains socket.
•
Do not use the power cable to drag the device.
•
Do not use the gas hose to drag the device.
•
Allow the device to cool down sufficiently.
•
Close the valve at the gas cylinder and disconnect the gas
hose.
•
Transport gas cylinder and device separately.
After
transporting the device, observe the following:
•
Please observe the information for device set-up:
•
Re-connect the gas hose and carry out a leak test (see
chapter Assembly and installation).
Storage
Before
storing the device, proceed as follows:
•
Close the valve at the gas cylinder and disconnect the gas
hose.
•
Allow the device to cool down sufficiently.
When the device is not being used, observe the following
storage conditions:
•
dry
•
under roof
•
in an upright position where it is protected from dust and
direct sunlight
•
with a cover to protect it from invasive dust, if necessary
•
Place no further devices or objects on top of the device to
prevent it from being damaged.
•
Store gas cylinder and device separately.
•
The storage temperature is the same as the range given
for the operating temperature in the technical data.
