12
EN
gas heater fan TGH 11 E / TGH 16 E / TGH 31 E
10sec
TGH 11 E / TGH 16 E
10sec
TGH 31 E
7. Then let go of the button (3).
ð
The combustion itself is an automatically controlled
process.
Info
Excessive temperature trips the overheating protection
which in turn interrupts the gas supply.
If the flame dies, the flame failure protection kicks in
which also interrupts the gas supply.
If the device switches off upon releasing the gas valve push
button (3), please proceed as follows:
1. Keep the fan running for approx. 1 minute to let the gas
escape completely.
2. Repeat the ignition process as described above.
Info
If you experience difficulties in lighting the torch, check
the air current.
Make sure that the fan is not blocked.
Make sure that air inlet and outlet are not obstructed.
If you use the device for an extended period of time, excessive
evaporation may cause a fine film to settle on the gas cylinder.
Info
Never direct the air outlet towards the gas cylinder!
Do not position the gas cylinder in front of the device!
Risk of fire and explosion!
1. Replace the gas cylinder with a new one or use a larger
gas cylinder.
Using the device as fan
You may also use the device as a fan for air circulation.
1. Make sure that the device is not connected to the gas
supply. The gas connection is rendered redundant during
the ventilation operation.
2. Remove the gas hose as appropriate.
3. Switch on the fan by setting the on/off switch (2) to
position
I
.
ð
The device now operates as fan.
Shutdown
1. Tightly close the valve at the gas cylinder.
ð
The flame goes out after a little while.
2. Keep the fan running for 3 minutes before switching the
device off.
3. Set the on/off switch (2) to position
0
.
4. Hold onto the mains plug while pulling the power cable out
of the mains socket.
5. Allow the device to cool down completely.
6. Disconnect the pressure reducer from the gas cylinder.
7. Loosen the hose connections at device and pressure
reducer.
8. Clean the device according to the Maintenance chapter.
9. Store the device according to the Storage chapter.
