NORMAL.DOT
Gespeichert in:G:\Support\Dokumentationen_CDs\8003Speedy\Service Manual\Servicemanual 8003.doc
Gespeichert am:2003/03/10
max
Version 14
Seite 68 von 87
I N D I V I D U A L M A R K I N G S Y S T E M S
-
A PC link cable (nomodem cable)
-
The firmware (here the two files loader.ini and loader.exe are very
important)
-
A set of allen keys metric
CAUTION:
To prevent an electric hazard never touch any part of the boards while
the machine is powered. Make sure that you do service work on an open machine
only when is installed to an electric network using an FI breaker o f max. 40mA.
1.) Open the service access panel (on the left side ot the machine) and the cover of
the electronic compartment.
2.) Place the jumper from the position closer to the Main board to the position closer
to the CPU board and connect one end of the link cable to the 9-pin socket closer
to the CPU board (if you have a set of first generation boards, otherwise you will
have only one 9-pin socket on the board)
3.) Open the loader.ini file, and select the COM port of the computer you are using
for updating the firmware (commport=0 for COM1 and commport=1 for COM2)
4.) Make sure that your engraver is switched on.
5.) Press the reset button on the CPU Board (black push button)
6.) Start the loader.exe file to begin with the update.
7.) Wait until you get the message: All files loaded successfully.
8.) Place back the blue jumper in it´s original position and close the panels again.
