SpeedMarker 300 /
ProMarker 300
Ausgabe 1.0
Technische Änderungen vorbehalten.
TROTEC Produktions- u. Vertriebs GmbH
Linzer Straße 156, A
– 4600 Wels
Seite
35
von 42
Switching On/Off
Press the master switch on the laser module.
The switch is illuminated in green and the two status lamps on the marking
head also illuminate in green (shutter closed).
Put the key in the key switch (vertically) and turn 90° to the right.
Press the “Error reset” button to reset the system to its normal state.
As soon as the door is closed …
System ready , Shutter and the two status lamps (red) on the marking head should now be illuminated.
The laser is now ready to start marking.
Start the PC. (The mains switch is located on the front behind the right hand cover. When operating the system
for the first time it may be necessary to check the master switch on the reverse side of the PC. In its normal
state this can remain in the “On” position.)
Now start the marking software on the PC
If an error occurs, the “Error Reset” button illuminates. Pressing this button acknowledges the error and the
system is then ready to continue operating.
Opening the door, while a marking process is running, will interrupt the laser beam immediately. The Error reset
button
…… will illuminate and must be reset before you can continue with your marking.
We recommending using only the key switch to pause the laser.
To completely turn off the laser, the main switch must be set to O.
Opening and closing the doorf
The door of the SpeedMarker 300 / ProMarker 300 is directly connected to the Interlock circuit. Therefore starting
a marking process is only possible with the door closed.
Simply use the black handle at the door to lift it and slide it down for opening and closing.
7
6
1
1
7
2
3
6
6
3
1
2
4
5
6
7
