EN
7
air cooler PAE 31
•
Do not create tripping hazards when laying the power
cable or other electric cables, especially when positioning
the device in the middle of the room. Use cable bridges.
•
Make sure that extension cables are completely unrolled.
•
Make sure that no curtains or other objects interfere with
the air flow.
Prior to initial start-up, insert batteries in the remote control.
Filling the water tank
The device requires fresh drinking water for air cooling.
Warning of electrical voltage
Before any work on the device, remove the mains plug
from the mains socket!
Do not touch the mains plug with wet or damp hands.
Hold onto the mains plug while pulling the power cable
out of the mains socket.
Note
Fill the device with fresh drinking water only. The
water temperature must not exceed 40 °C.
Info
If possible, change the water every 3 days to prevent
bacterial growth.
Info
Optionally, you can put ice packs into the water tank
for additional cooling.
Observe the following when using the ice packs:
•
Put the ice packs into a freezer for at least 4 hours before
use.
•
Put the ice packs into the water tank before filling water
into the tank.
Info
When using ice packs at high outside temperatures,
condensation may form at the water tank and drip onto
the floor.
1. Disconnect the device from the mains before refilling water
or putting ice packs into the device.
2. Release the water tank (
7
) by turning both clips from their
vertical position into the horizontal position.
3. Remove the water tank (
7
) from the device.
7
4. If required, put the ice packs into the water tank for
additional cooling.
